Equinix FR5 (formerly Ancotel) is the pioneer of neutral interconection in Germany. It is located in the center of an area, known as "KleyerStrasse", where some of the largest datacenter facilities in Frankfurt are located. Over 220 networks publicly advertise they have a point of presence in Equinix FR5, among them DE-CIX, the largest public Internet Exchange in the world.

Location

Power

Power Lines

	SETUP	MONTHLY
2 x 32A / 230V redundant power lines – Each line is sourced from a different UPS and has its own circuit breaker that triggers when the line 32A rating is reached. – Power lines are installed close enough to rack cabinet to allow PDUs to be connected with their own cable. The PDUs, ideally, should have the same Voltage and Amperage rating as the lines. If they don’t, they must be equipped with circuit breakers from the factory. – Each power line has a single IEC 60309 (formerly known as IEC309) 32A 2P+E receptacle that allows to connect one PDU per line. – Equipment installed in rack cabinet ideally would have two power sources, each one connected to a different power line to achieve power redundancy. – Equipment with one power source should be connected balanced between power lines and they will not be protected against one line power failures.	-	-

Power Consumption

	SETUP	MONTHLY
4 kVA maximum power draw from all power lines in a Equinix EU Datacenter – Or 17.4A @ 230V or 2880 kWh/month Power plan can be upgraded and we will notify you if the draw is higher than the one contracted (Each additional 0,1 kVA power draw above 4 kVA included is charged with an excessive usage fee of: $145.80/0,1 kVA)	-	-
5 kVA maximum power draw from all power lines in a Equinix EU Datacenter – Or 21.7A @ 230V or 3600 kWh/month Power plan can be upgraded and we will notify you if the draw is higher than the one contracted (Each additional 0,1 kVA power draw above 5 kVA included is charged with an excessive usage fee of: $145.80/0,1 kVA)	-	+$558.36
6 kVA maximum power draw from all power lines in a Equinix EU Datacenter –Or 26A @ 230V or 4320 kWh/month – Even if each power line (or all power lines combined) can support a higher power draw (consumption) the datacenter does not allow this because of: (a) UPS provisioned capacity, (b) loss of redundancy in case load moves to a single line due to one line power failure (c) cooling provisioned capacity for this rack cabinet and (d) electricity cost. – Going above the power draw threshold can put you at risk of power disconnection. – The most efficient power schema is to draw almost the entire power allowed under normal usage condition and configure the equipment to start randomly at power-up. This will avoid power-on spikes that might trigger the circuit breakers.	-	+$1117.80

Colocation Support

SLA for Colocation

	SETUP	MONTHLY
Standard SLA for a Colocation service. 'Remote hands' This SLA assumes the equipment is installed by customer and works well, no hardware changes are expected and only occasional simple emergency requests might be required. Standard SLA includes unlimited number of requests for power cycles, visual inspection of equipment, access to a shared remote KVM along with very simple tasks for hot-plug components or cables like 'plug / unplug' or 'take .. from .. and replace .. '. The SLA does not cover installation/removal/replacement of non-hot plug components or any hardware or software troubleshooting. Requests under this SLA are executed first come, first served by 24/7 on-site datacenter personnel under the assumption they are 'urgent'. Under normal operation conditions such requests are executed in less than 30 minutes, but no guarantee is provided. (On-site support not included in Standard SLA is charged: $54.00/Hour)	-	-
Expert SLA for a Colocation service. 'Remote Hands and Expert Installation' This SLA covers two batches of equipment physical installation in rack cabinet at a agreed date and later, packaging and shipping. Cost of packaging material, shipping and import/export duties are charged separately. It also covers expert cabling of Internet, private, management and out-of-band networks and the cost of all UTP cables and patches. It doesn't cover fiber and twinaxl patches that must be purchased separately. The Expert SLA includes software configuration of ILO / DRAC / IMM management ports and troubleshooting to power up the equipment. The post-install maintenance includes unlimited number of requests for power cycles, visual inspection of equipment, access to a shared remote KVM along with very simple tasks for hot-plug components or cables like 'plug / unplug' or 'take .. from .. and replace .. '. The SLA does not cover installation/removal/replacement of non-hot plug components or any troubleshooting outside the two initial installation/removal batches. Maintenance requests under this SLA are prioritized over Standard SLA and executed first come, first served by 24/7 on-site datacenter personnel under the assumption they are 'urgent'. Under normal operation conditions such requests are executed in less than 30 minutes, but no guarantee is provided. (On-site support not included in Expert SLA is charged: $54.00/Hour)	+$648.00	-
Ultimate SLA for a Colocation service. 'Everything you need' This SLA assumes the equipment must be imported, installed, removed and exported in at least 3 batches every year and equipment or cabling might need expert troubleshooting, including replacing of non hot-plug components. This is the case with companies that changes their infrastructure frequently. SLA covers unlimited batches of equipment physical installation at agreed dates in rack cabinet and at a later date packaging and shipping. Cost of packaging material, shipping and import/export duties are charged separately. It also covers expert cabling of Internet, private, management and out-of-band networks and the cost of all UTP cables and patches. It doesn't cover fiber and twinal patches that must be purchased separately. The Ultimate SLA includes software configuration of ILO / DRAC / IMM management ports and troubleshooting to power up the equipment. The post-install maintenance includes unlimited number of requests for power cycles, visual inspection of equipment, access to a shared remote KVM along with expert tasks for hardware troubleshooting and replacement using spare parts available on site. Maintenance requests under Ultimate SLA are of highest priority and executed first come, first served 24/7 by Voxility own on-site datacenter personnel. Under normal operation conditions such requests are executed in less than 30 minutes, but no guarantee is provided.	+$1080.00	+$216.00

Connectivity

Cross Connects Patch Panel

Fiber Connectivity

	SETUP	MONTHLY
Fiber Panel (ODF) precabling with 24 single mode fiber pairs (LC) in Equinix FR5	-	-

Full Rack Cabinet Colocation in
Equinix KleyerStrasse FR5 Frankfurt

Product Specifications

Location

Power

Power Lines

Power Consumption

Colocation Support

SLA for Colocation

Connectivity

Cross Connects Patch Panel

Fiber Connectivity

Choose from available quotes linked to this account

Step 1. Page format

Step 2. Offer content

Full Rack Cabinet Colocation in Equinix KleyerStrasse FR5 Frankfurt

Product Specifications

Location

Power

Power Lines

Power Consumption

Colocation Support

SLA for Colocation

Connectivity

Cross Connects Patch Panel

Fiber Connectivity

Add to Quote

Choose from available quotes linked to this account

Export This Offer

Step 1. Page format

Step 2. Offer content

Full Rack Cabinet Colocation in
Equinix KleyerStrasse FR5 Frankfurt