CoreSite's LA2 data center provides unmatched scalability within the Los Angeles market. Comprised of nearly 425,000 square feet of data center space and tethered via high-count dark fiber to CoreSite’s LA1 (One Wilshire) data center, LA2 offers customers room to grow. Being connected directly with to Coresite LA1 it offers the access to Any2 Internet Exchange that has over 235 networks connected that exchange traffic increasing quality and lowering IP transit cost.

Location

Power

Power Lines

	SETUP	MONTHLY
2 x 20A / 208V redundant power lines in Coresite LA1, LA2 and VA1 – Each line is sourced from a different UPS and has its own circuit breaker that triggers when the line 20A rating is reached. – Power lines are installed close enough to rack cabinet to allow PDUs to be connected with their own cable. The PDUs, ideally, should have the same Voltage and Amperage rating as the lines. If they don’t, they must be equipped with circuit breakers from the factory. – Each power line has a single NEMA L6-20R receptacle (requires NEMA L6-20P plug) that allows to connect one PDU per line. – Equipment installed in rack cabinet ideally would have two power sources, each one connected to a different power line to achieve power redundancy. – Equipment with one power source should be connected balanced between power lines and they will not be protected against one line power failures.	-	-
2 x 30A / 208V redundant power lines in Coresite LA1, LA2 and VA1 – Each line is sourced from a different UPS and has its own circuit breaker that triggers when the line 30A rating is reached. – Power lines are installed close enough to rack cabinet to allow PDUs to be connected with their own cable. The PDUs, ideally, should have the same Voltage and Amperage rating as the lines. If they don’t, they must be equipped with circuit breakers from the factory. – Each power line has a single NEMA L6-30R receptacle (requires NEMA L6-30P plug) that allows to connect one PDU per line. – Equipment installed in rack cabinet ideally would have two power sources, each one connected to a different power line to achieve power redundancy. – Equipment with one power source should be connected balanced between power lines and they will not be protected against one line power failures.	-	-

Power Consumption

	SETUP	MONTHLY
3.33 kW maximum power draw from all power lines in Coresite LA1, LA2 and VA1 – It is the rough equivalent of 16A @ 208V or 2400 kWh/month or 9500 Watts of primary server sources used at 35% – Even if each power line (or all power lines combined) can support a higher power draw (consumption) the datacenter does not allow this because of: (a) UPS provisioned capacity, (b) loss of redundancy in case load moves to a single line due to one line power failure (c) cooling provisioned capacity for this rack cabinet and (d) electricity cost. – Going above the power draw threshold can put you at risk of power disconnection. – The most efficient power schema is to draw almost the entire power allowed under normal usage condition and configure the equipment to start randomly at power-up. This will avoid power-on spikes that might trigger the circuit breakers.	-	-

Colocation Support

SLA for Colocation

	SETUP	MONTHLY
Standard SLA for a Colocation service. 'Remote hands' This SLA assumes the equipment is installed by customer and works well, no hardware changes are expected and only occasional simple emergency requests might be required. Standard SLA includes unlimited number of requests for power cycles, visual inspection of equipment, access to a shared remote KVM along with very simple tasks for hot-plug components or cables like 'plug / unplug' or 'take .. from .. and replace .. '. The SLA does not cover installation/removal/replacement of non-hot plug components or any hardware or software troubleshooting. Requests under this SLA are executed first come, first served by 24/7 on-site datacenter personnel under the assumption they are 'urgent'. Under normal operation conditions such requests are executed in less than 30 minutes, but no guarantee is provided. (On-site support not included in Standard SLA is charged: $54.00/Hour)	-	-
Expert SLA for a Colocation service. 'Remote Hands and Expert Installation' This SLA covers two batches of equipment physical installation in rack cabinet at a agreed date and later, packaging and shipping. Cost of packaging material, shipping and import/export duties are charged separately. It also covers expert cabling of Internet, private, management and out-of-band networks and the cost of all UTP cables and patches. It doesn't cover fiber and twinaxl patches that must be purchased separately. The Expert SLA includes software configuration of ILO / DRAC / IMM management ports and troubleshooting to power up the equipment. The post-install maintenance includes unlimited number of requests for power cycles, visual inspection of equipment, access to a shared remote KVM along with very simple tasks for hot-plug components or cables like 'plug / unplug' or 'take .. from .. and replace .. '. The SLA does not cover installation/removal/replacement of non-hot plug components or any troubleshooting outside the two initial installation/removal batches. Maintenance requests under this SLA are prioritized over Standard SLA and executed first come, first served by 24/7 on-site datacenter personnel under the assumption they are 'urgent'. Under normal operation conditions such requests are executed in less than 30 minutes, but no guarantee is provided. (On-site support not included in Expert SLA is charged: $54.00/Hour)	+$648.00	-
Ultimate SLA for a Colocation service. 'Everything you need' This SLA assumes the equipment must be imported, installed, removed and exported in at least 3 batches every year and equipment or cabling might need expert troubleshooting, including replacing of non hot-plug components. This is the case with companies that changes their infrastructure frequently. SLA covers unlimited batches of equipment physical installation at agreed dates in rack cabinet and at a later date packaging and shipping. Cost of packaging material, shipping and import/export duties are charged separately. It also covers expert cabling of Internet, private, management and out-of-band networks and the cost of all UTP cables and patches. It doesn't cover fiber and twinal patches that must be purchased separately. The Ultimate SLA includes software configuration of ILO / DRAC / IMM management ports and troubleshooting to power up the equipment. The post-install maintenance includes unlimited number of requests for power cycles, visual inspection of equipment, access to a shared remote KVM along with expert tasks for hardware troubleshooting and replacement using spare parts available on site. Maintenance requests under Ultimate SLA are of highest priority and executed first come, first served 24/7 by Voxility own on-site datacenter personnel. Under normal operation conditions such requests are executed in less than 30 minutes, but no guarantee is provided.	+$1080.00	+$216.00

Connectivity

Cross Connects Patch Panel

Fiber Connectivity

	SETUP	MONTHLY
Instant activation
Do not install any Fiber Patch Panel – Cross Connects will not be possible to be originated or terminated in this rack cabinet and will be left out with any kind of connectivity. – Still, this rack cabinet can be connected with a small number of fiber or other types of cables to an adjacent rack cabinet you previously rented. This solution works only if both rack cabinets are next to each other (have a common side).	-	-
Delivery in 7 days or less
Fiber Patch Panel with 12 single mode fiber pairs - LC receptacles in CoreSite LA1, LA2 and VA1 – Required to order any type of Cross Connects originated or terminated in this rack cabinet. – Up to 12 Cross Connects can be ordered. If needed, additional Fiber Patch Panels can be installed. – It uses 1 RU of your rack cabinet and it is tipically installed at the very top of the cabinet. – Cross Connects installed in this Fiber Patch Panel will have LC blue receptacles. To link your equipment to a Cross Connect a secondary 1-3m single mode fiber patch will be required. That patch must have at one end LC blue plug and at the other end your equipment connector type (typically the same blue LC). – CoreSite provides this service under the name Patch Panel.	-	-

Full Rack Cabinet Colocation in
CoreSite LA2 Los Angeles

Product Specifications

Location

Power

Power Lines

Power Consumption

Colocation Support

SLA for Colocation

Connectivity

Cross Connects Patch Panel

Fiber Connectivity

Choose from available quotes linked to this account

Step 1. Page format

Step 2. Offer content

Full Rack Cabinet Colocation in CoreSite LA2 Los Angeles

Product Specifications

Location

Power

Power Lines

Power Consumption

Colocation Support

SLA for Colocation

Connectivity

Cross Connects Patch Panel

Fiber Connectivity

Add to Quote

Choose from available quotes linked to this account

Export This Offer

Step 1. Page format

Step 2. Offer content

Full Rack Cabinet Colocation in
CoreSite LA2 Los Angeles